Ultimaker 3 feeder grinding free
Looking for:
Ultimaker 3 feeder grinding free
Ultimaker 3 feeder grinding free -
The goal is not to yank the filament free, just to get it out of the divot so the feeder can remove it properly. After you are out of the. It should hold 10 to 15 pounds and still move. If not then feeder is problem. If it holds then something in core is most likely problem.
- Ultimaker 3 feeder grinding free
Sep 27, · Hey everyone, eventhough this is not a new topic, I keep having trouble with filament grinding on my Ultimaker Original. I've had this printer since and this is the first real headache I've had with printing. The problem occured a while back when I noticed that longer prints weren't as good. Pardon my english but I'll try to explain myself. I had the exact same problem with Ultimaker 2. After looking hours and hours at the feeder, I discovered problem was coming from the other side of the transparent tube hanging on your pic. This tube wasn't pushed enough toward the nozzle before securing it with the little plastic thing. Sep 03, · Posted August 20, · Filament keeps grinding. I've measured the filament many times to check. It is mm. I calculated an average variation on diameter to mm i.e - 2 micron from 10 sample points per meter, measuring x any y directions to see any sort of elliptical cross section. I was impressed at the consistency.
.
If the extrusion rate was too high, I would expect to see some surface deformation of the extruded polymer. When attempting to remove filament from a feeder with grinding issues, I recommend attempting to do an "assisted reverse" of the filament. I have not observed any slickness when I brushed it off by hand.
Comments
Post a Comment